Filter
Top Products
1 Bobbin (3) 136492-101
2 Seam ripper X54243-001
3 Screw XA5904-051
4 Scissors 184783-001
5 Chalk pen 184944-001
6 Cleaning brush XA4527-001
7 Eyelet punch 135793-001
8 Screwdriver (Large) X55467-051
9 Screwdriver (Small) X55468-051
10 Spool cap (Small) 130013-003
11 Spool cap (Large) 130012-003
12 Extra spool pin* XA3336-051
13 Spool felt X57045-001
14 Disc-shaped screwdriver XA2005-051
15 Walking foot* X81064-001
16 Side cutter X80943-001
17 Embroidery set (Regular) SA422 X80903-002
18 Embroidery frame (Regular) XA2171-101
19 Embroidery sheet (Regular) XA2212-001
20 Net* 127610-000
21 Embroidery set (Large) SA423 X80902-002
22 Embroidery frame (Large) XA2168-201
23 Embroidery sheet (Large) XA2209-001
24 Embroidery set (Small) SA421 X80904-102
25 Embroidery frame (Small) XA2174-101
26 Embroidery sheet (Small) XA2215-101
27 Screw* XA4813-051
28 Foot controller 234522-001
29 Pattern Sheet XA4595-001
30 Hard case XA1821-106
31 Knee Lifter XA6941-001
32 Embroidery bobbin thread SA-BTS X81164-001
7
OTHER INCLUDED ACCESSORIES
123
456
789
10 11 12
13 14 15
16 18
17
19
20 22 23
25 26 27
28 29
31 32
30
21
24
No.Part Name
Part Code
U.S.A. Others
* Use the same screw when installing both the
side cutter and the walking foot.
* If using special threads which wind quickly off
the thread spool, place a net on the spool
before using.
* If using the walking foot,
please refer to the
explanatory sheet which is
inserted in the instruction
book.
* The extra spool pin which is
provided as an accessory
should be attached to the
end of the bobbin winder
shaft during use.
Note (For U.S.A. only)
Foot controller: Model J2
This foot controller can be used for this machine
model PC-8500.
Utility
Stitches
Characters
and
Decorative
Stitches
Embroidering
Editing
Embroidery
Patterns
Retrieving
My
Custom
Stitch
TM
Maintenance
Error
Messages
Trouble
shooting
Sewing
Chart
Patterns
(Programmed
in Machine)
Patterns
(Memory
Card)
Sewing
Setting Up