Filter
Top Products
55
Utility
Stitches
Characters
and
Decorative
Stitches
Embroidering
Editing
Embroidery
Patterns
Retrieving
My
Custom
Stitch
TM
Maintenance
Error
Messages
Trouble
shooting
Sewing
Chart
Patterns
(Programmed
in Machine)
Patterns
(Memory
Card)
Sewing
Setting Up
5
3
5. Press the “START/STOP” button to start the machine, while
gently holding the end of the upper thread.
* Gently, feed the fabric by hand.
* The machine will stop with a reinforcement stitch
automatically after sewing is completed.
* If you touch the automatic thread cutting key prior to sewing,
the machine cuts both threads automatically after sewing is
completed.
* If the fabric will not feed (for instance, because it is too
thick), touch the “ ” stitch length setting key to increase
the stitch length.
6. Open the buttonhole.
Normal buttonhole and rounded buttonhole
Insert a pin in front of the inside edge of both bar tacks. Insert
the seam ripper into center of buttonhole. Cut towards the first
pin. Then cut toward the other pin.
1 Pin
Keyhole buttonhole
Make a hole using the small eyelet punch in the key end, insert a
pin into the inside edge of the bar tack. Insert a seam ripper into
the hole made with the eyelet punch and cut towards the pin.
1 Small eyelet punch (accessory #7 on page 7)
2 Pin