Filter
Top Products
1
2
2. Pass the thread underneath the presser foot and pull it out
from the rear of the machine by about 5 cm.
1 Upper thread
2 5 cm (1-15/16”)
5
3. While holding on the thread tails and the fabric with your left
hand, turn the balance wheel with your right hand to move
the needle to the sewing start position.
1 Thread
* Sewing can begin without pulling out the bobbin thread.
5
3
4. Lower the presser foot. Press the “REVERSE STITCH”
button to sew a reverse stitch, and then press the
“START/STOP” button. The machine will start to run at slow
speed.
5
3
5. When sewing is completed, press the “REVERSE STITCH”
button to sew a reverse stitch.
5
6. Press the “THREAD CUTTER” button to cut the threads .
*6. Cut thick thread (thicker than # 30) with the cutter on the
side of the machine as illustrated.
* BOBBIN THREAD SENSOR
If a warning message appears on the message screen, the
bobbin thread is running out. Replace the bobbin thread at
this time.
37
Utility
Stitches
Characters
and
Decorative
Stitches
Embroidering
Editing
Embroidery
Patterns
Retrieving
My
Custom
Stitch
TM
Maintenance
Error
Messages
Trouble
shooting
Sewing
Chart
Patterns
(Programmed
in Machine)
Patterns
(Memory
Card)
Sewing
Setting Up