Filter
Top Products
VideoJet 8008 / VideoJet 8004 | Installation and Operating Manual
EN | 97
Bosch Security Systems | 2006-07 | V1.5 Configuration using a Web browser
Alarm connections
You can select how the unit responds to an alarm. In the event of an alarm, the
unit can automatically connect to a pre-defined IP address. You can enter up to
ten IP addresses to which the unit will connect in sequence in the event of an
alarm, until a connection is made. You can also select which camera image
should automatically be shown first on the receiver in the event of an alarm.
Connect on alarm:
Select On so that the unit automatically connects to a predefined IP address in
the event of an alarm.
Note
Dual Streaming compatible units only: Stream 2 is always transferred for
alarm connections. Bear this fact in mind when assigning the profile (see
page 72).
Number of destination IP address:
Specify the numbers of the IP addresses to be contacted in the event of an
alarm. The unit contacts the remote stations one after the other in the numbered
sequence until a connection is made.
Destination IP address:
For each number, enter the corresponding IP address for the desired remote
station.
Destination password:
If the remote station is password protected, enter the password here.