Filter
Top Products
Installation and Operating Manual | VideoJet 8008 / VideoJet 8004
EN | 46
Configuration using a Web browser Bosch Security Systems | 2006-07 | V1.5
Alarm recording at:
You can select the alarm sensor that is to trigger a recording. You can also use
the motion and video alarm for a camera to trigger the alarm recording by
another camera.
Note
The alarm sensor must be active to be able to trigger the recording. The
alarm inputs and video loss alarms are activated on the Alarm settings
page (see page 51). The motion alarms are configured and activated for
each camera on the Motion detector page (see page 99).
– Check the box for the alarm sensor that is to trigger a recording. The selected
check boxes are marked with a tick.
Note
The numbers of the alarm input check boxes correspond to the labeling of
the alarm inputs on the rear panel of the unit. The motion and video loss
alarm numbers correspond to the labeling of the video inputs.
Partition total size:
This displays how much storage space the partition occupies on the hard drive.
Remaining for recording:
This displays the maximum remaining recording time. The value is automatically
updated after the parameters have been modified.
Free space on partition:
This displays how much space is still available in the partition.
Recording status:
The graphic indicates the recording activity in this partition. You will see an ani-
mated graphic while recording is taking place.
Format
You can delete all recordings in a partition at any time.
Caution
Check the recordings before deleting and back up important sequences on
the computer's hard drive.
–Click the
Format
button to delete all recordings on the currently selected partition.