Filter
Top Products
VideoJet 8008 / VideoJet 8004 | Installation and Operating Manual
EN | 55
Bosch Security Systems | 2006-07 | V1.5 Configuration using a Web browser
Network settings
Here you can specify network addresses and configure multiple connections.
Network
The settings in this screen are used to integrate the unit into an existing network.
Caution
Changes to the IP address, subnet mask or gateway address are trans-
ferred to the unit by clicking Set. However, they only take effect after the
unit is restarted.
– Click Set after entering a new IP address.
– Enter the old IP address followed by /reset (for example
192.168.0.88/reset) in your Web browser's address bar. The unit restarts
and can then only be accessed at the new IP address.
Unit IP address:
Enter the desired IP address for the unit. The IP address must be valid for the
network.
Subnet mask:
Enter the appropriate subnet mask for the selected IP address here.