Filter
Top Products
Installation and Operating Manual | VideoJet 8008 / VideoJet 8004
EN | 108
Configuration using a Web browser Bosch Security Systems | 2006-07 | V1.5
Ethernet link type:
If the unit is connected to the network via a switch, both must have the same
default for the type of network connection. If necessary, ask your network admin-
istrator what value the switch is set to.
The Auto setting automatically detects the network connection. If necessary,
you can specify the value 10 or 100 MBit/s for full or half-duplex mode (FD or
HD) or 1 GBit/s FD.
Caution
Malfunctions such as image faults can occur if the network does not have
enough capacity to transmit the maximum data rate generated by the unit.
Dynamic DNS server IP address:
When operating a unit on the Internet, dynamic addresses are used to ensure effi-
cient use of the available IP address pool. That is, the unit is reassigned a (chang-
ing) IP address each time a new connection is made. Access is easier if the unit
is listed in a DNS server. It registers there at regular intervals and leaves the unit
name and its IP address. If you wish to establish an Internet connection to a unit,
it is sufficient to enter the appropriate unit name together with the URL of the
DNS server. This then reports on the current Internet IP address used to estab-
lish the connection.
Dynamic DNS contact interval:
Enter the desired refresh interval in seconds here.