Filter
Top Products
Configuration
3–36 975-0704-01-01 Revision A
Clearing the Internal Firmware Memory
To clear the Conext ComBox internal firmware memory:
1. Turn off the Conext ComBox by shutting it down and disconnecting all its
power sources. Make sure the Power LED is off. Wait ten seconds before the
next step.
2. Insert a pointed object such as a paper clip into the Reset pinhole and press
the button while turning on the Conext ComBox by reconnecting to its power
source.
3. Continue holding the Reset pinhole button until all indicator LEDs flash
quickly five times (approximately 10 seconds). Continue to hold the button
until the LEDs flash slowly (approximately 5 seconds). When the memory has
been cleared, the Status and Power LEDs are on and a firmware upgrade
must be done.
Note
: Clearing internal firmware memory should be done for Conext ComBox
upgrades only. It is not necessary for upgrades to other devices on the network.
Quick flashes
Slow flashes
10 seconds
elapsed time
5 seconds
elapsed time
Continue to hold the Reset pinhole
to bypass the Reset to Factory
Settings procedure.
The Upgrading Firmware
procedure starts here.