Filter
Top Products
Mounting the Conext ComBox
975-0704-01-01 Revision A 2–5
DIN Rail Mount
A standard 35-mm “top hat” DIN rail (EN50022) must be used for mounting.
To mount the Conext ComBox on the DIN Rail:
1. Choose the location for mounting the device.
2. Using heavy duty scissors or a diagonal cutter, cut both ends of the side tab
on one end of the Conext ComBox.
3. Break off the side tab. You may need to use pliers for this.
4. Repeat steps 2 and 3 for the tab at the other end of the Conext ComBox.
5. Use a suitable tool, such as a screwdriver, to pull down the catch on the
bottom of the Conext ComBox.
6. Mount the Conext ComBox on the DIN rail and release the catch. See the
following illustration.
7. Connect the wiring and cables.
Side tab
DIN rail catch