Filter
Top Products
Configuration
3–24 975-0704-01-01 Revision A
Dry Contact Relay
You can set the Relay Mode of Operation to Automatic so that the relay will
automatically go on if a fault is detected in the system.
To manually control the mode of operation so that the relay is always on (or off),
select On (or Off).
Suppress Device Faults/Warnings
You can suppress certain fault and warning codes from being included in the
device reports that are sent to E-Mail Recipients specified in E-Mail Settings.
List the fault and warning codes for each device you want to exclude in the report
by entering the name of the code. Separate multiple codes by comma.
The fault and warning codes for all the devices are usually listed under the
Troubleshooting section of the device’s Owner’s Guide.