Filter
Top Products
Installation
2–12 975-0704-01-01 Revision A
Connecting the AC/DC Power Adapter
To use the AC/DC power adapter supplied with the Conext ComBox as a
power source:
1. Conext ComBox uses a universal plug with interchangeable pins and plug
styles.
2. Connect the power plug to the AC outlet.
3. Connect the other plug of AC/DC power adapter to the Power port on the
Conext ComBox.
4. Go to step 2 of “Turning On the Conext ComBox”.
Wiring the RS 485 Modbus Connector for Power to the Conext ComBox
To use the Modbus RS 485 connector to provide power to the Conext ComBox,
use the following procedure. When powering the Conext ComBox through the
24 V DC terminals on the RS 485 connector, use a power supply (AC/DC or DC/
DC) that provides galvanic isolation to meet the required SELV connections.
DANGER
ELECTRIC SHOCK AND FIRE HAZARD
Use only the AC/DC Power Adapter supplied with this Conext ComBox unit.
When ordering a replacement, reference PN: 0J-921-0023-Z.
Failure to follow these instructions will result in death or serious injury.
Note: Modbus support is available only for the Conext ComBox (Part Number
865-1058), and Conext Modbus Converter (Part Number 865-1059), used with
Schneider Electric Conext series inverter products.
The RS 485 Modbus connector supplied with this Conext ComBox – Freedom
SW (Part Number 809- 0918), is not required for operation or supported by
Xantrex technical support.