Filter
Top Products
Configuration
3–30 975-0704-01-01 Revision A
System Diagram
Use this setting to include (checked box) or exclude (unchecked box) system
diagrams of each electrical system component as displayed in the Home screen.
Resetting the Conext ComBox to Factory Settings
If you need to return the Conext ComBox to all of the original factory settings, you
can perform a reset.
To reset the Conext ComBox to original factory settings:
1. Turn off the Conext ComBox by shutting it down properly (as shown on
page 3–17) and then disconnecting all its power sources. Make sure the
Power LED is off. Wait ten seconds before the next step.
To turn the unit on, insert a pointed object such as a paper clip into the Reset
pinhole, and press the button while reconnecting the Conext ComBox’s
power source.
2. Continue pressing (holding) the Reset pinhole button until all indicator LEDs
flash quickly five times (approximately 10 seconds) and then quickly release
the button.
quick flashes
10 seconds
elapsed time