Filter
Top Products
Changing Advanced Conext ComBox Settings
975-0704-01-01 Revision A 3–27
Modbus Address List
Use this function to change the Modbus address of a device. The Conext
ComBox automatically assigns addresses when it is installed, but individual
values can be changed as necessary. The default addresses are assigned per
device type.
To change a device Modbus address:
1. In Setup, click Modbus Address List.
The expanded window displays a table of addresses that are already
reserved along with the associated device, its ID and On Line status.
2. To change a device Modbus address:
• Select the Device from the drop-down list.
Its address is displayed in the address box.
If you want to make sure you have selected the correct device:
Note
: Modbus support is available only for the Conext ComBox (Part Number
865-1058), and Conext Modbus Converter (Part Number 865-1059), used with
Schneider Electric Conext series inverter products.
The Modbus Address List option available with this Conext ComBox – Freedom
SW (Part Number 809- 0918), is not required for operation or supported by
Xantrex technical support.
Note: To change the initial starting address settings, see “Modbus Address
Enumeration”.
Note: Valid Modbus addresses are listed from 1 to 247. The rest are assigned
special meanings.