Filter
Top Products
Configuration
3–28 975-0704-01-01 Revision A
Click and a physical indicator on the device will flash, light up, or
beep depending on the device.
• Click to make sure you view the latest information.
• Enter the new address for the device in the address box. Do not use an
address that is already reserved.
• Click Submit to save the address change.
To reset all of the device Modbus addresses to their default values:
u In Modbus Address List, click Reset Addresses.
Modbus Address Enumeration
Use this setting to change the initial starting Modbus addresses for device types.
The Conext ComBox automatically assigns starting addresses when it is installed
but the starting values can be changed as you wish.
Note: Modbus support is available only for the Conext ComBox (Part Number
865-1058), and Conext Modbus Converter (Part Number 865-1059), used with
Schneider Electric Conext series inverter products.
The Modbus Address Enumeration option available with this Conext ComBox –
Freedom SW (Part Number 809- 0918), is not required for operation or
supported by Xantrex technical support.