Filter
Top Products
78 SSCI - Suburban Surgical Company, Inc.
Chapter 5 - Repairs & Replacements
Latch Connector
Holder
P/N 618479
The latch connector holders hold the latch connectors in place on
the compartment doors. There is one top and one bottom latch
connector holder on each animal compartment door. The four
holders are identical and are removed and installed the same way.
The holders can be replaced without removing the doors.
Tool Required
Phillips screwdriver
Removal
1. Open the door.
2. With a Phillips screwdriver, remove the two cap screws
that secure the latch connector holder to the unit (Figure 86)
and remove the holder from the door.
Installation
1. Hold the latch connector holder in place on the door and
secure with the two cap screws. Note: The locating pins
(Figure 86) in the latch connector should ride above the top
latch connector holder, and under the bottom latch
connector holder.
2. Close and latch the door.
Figure 86. Latch Connector and Holder
Latch
Connector
Latch
Connector
Holder
Locating Pin
Cap Screw
(2)