Filter
Top Products
Form No. 702718 Rev. A March, 2005
137
Owner’s Manual - Regal Intensive Care Unit
Chapter 6 - Troubleshooting
General
The following procedures will help you fix most of the problems
that you might encounter with your SSCI Regal Intensive Care
Unit. If necessary, please feel free to call SSCI Customer Service
at (847) 537-9320, ext. 3518 (in Illinois) or 1-800-323-7366.
Our experienced technical support personnel will be glad to help you.
For more information on contacting SSCI, refer to SSCI Contact
Information on Page 7.
Part numbers for available replacement parts are shown in Table 3
on Pages 71 and 72. To order replacement parts, refer to Parts
Ordering Procedure on Page 73.
WARNING: Oxygen is a highly combustible gas. Avoid the use of open flames,
smoking materials, or equipment capable of producing sparks in any area in
which oxygen is being used. Before servicing or performing maintenance on
this equipment, make sure the oxygen supply is turned Off at the source.
Possible problems are listed below:
ICU will not turn on. ........................................................................................ Page 139
Circuit breakers keep tripping. ...................................................................... Page 140
Oxygen flow is inadequate. ............................................................................ Page 141
Oxygen flow is excessive. .............................................................................. Page 142
Alarm keeps going off.................................................................................... Page 143
Alarm system does not work. ......................................................................... Page 144
Heat will not come on or will not hold constant. ............................................... Page 145
Cooling will not come on or will not hold constant. .......................................... Page 146
Floor heat doesn’t work or will not hold constant. ............................................ Page 147
Ventilating fan does not work. ........................................................................ Page 148
Circulating fan does not work. ........................................................................ Page 149
No readings on digital readout. ...................................................................... Page 150
Excessive carbon dioxide in the animal compartment. ................................... Page 151
No reading on oxygen concentration meter. ................................................... Page 152
Calibration knob will not move the calibration needle. .................................... Page 153
Cannot move the set-point needle in the oxygen concentration meter ............. Page 154
Floor temperature fuse keeps blowing. .......................................................... Page 155