Filter
Top Products
Form No. 702718 Rev. A March, 2005 103
Owner’s Manual - Regal Intensive Care Unit
3. Pass the connectors and wires through the knurled ring and
screw the ring firmly onto the button body until holds the
button tightly onto the door.
4. Locate the remaining gray wire that you cut off the system
light in Step 8 above.
5. Strip off about 1/2-in. of the insulation from the end of the
wire, leaving the bare metal strands exposed.
6. Twist the bare metal strands of this wire together with the
strands from the gray wire on the new button assembly.
7. Place a new spade connector onto the two wires and, with
a wire crimping took, firmly crimp the connector to the
wires. Tug on the connection to make sure it is tight and
secure.
8. Connect this spade connector to the rear of the system
light (Figures 114 and 115).
9. Plug the connector on the green and white wires onto
Terminal 4 on the temperature control assembly.
10. Plug the connector on the green wire onto Terminal 6 on the
temperature control assembly.
11. Plug the connector on the red wire to the side terminal on
the fuse holder.
12. Close and secure the electronics compartment door.
13. Plug the power cord into its wall outlet.