Filter
Top Products
50
SSCI - Suburban Surgical Company, Inc.
Chapter 4 - Operation and Care
3. Orient the divider panel so that the notched corner is on
top and toward the front (Figure 53).
4. Tilt the top of the divider panel to the left, and place it into
the top guide channel.
5. Swing the lower edge of the panel to the left so that it is
vertical.
6. Push the panel to the rear so that the back edge seats in the
rear guide channel.
7. Replace the PVC floor, if desired.
Removal
1. Open both doors.
2. Remove the PVC floor (if installed) in the right
compartment.
3. Grasp the front edge of the divider panel and pull it out
until the back edge of the panel clears the rear channel.
4. Tilt the lower edge of the divider panel to the right until the
top edge clears the top guide channel.
5. Remove the divider panel from the unit.
6. Replace the PVC floor, if desired.