Filter
Top Products
Form No. 702718 Rev. A March, 2005 133
Owner’s Manual - Regal Intensive Care Unit
9. The rear of the heater is mounted to a bracket similar to
the front. Remove the screw/nut holding the rear end of
the heater to the mounting bracket.
10. Lift out the heater.
Installation
1. Hold the heater in position and mount the rear end to the
mounting bracket with the screw/nut removed earlier
(Figure 156).
2. Mount the front end of the heater to the mounting bracket
with the screw/nut removed earlier.
3. Connect both wires to the terminals on the front end of
the heater.
4. Re-mount the rear utility panel and secure with the
eleven screws.
5. Replace the Sodalime pan.
6. Replace and secure the filter/fans compartment panel.
7. Plug the power cord into its wall outlet.