Filter
Top Products
Form No. 702718 Rev. A March, 2005 129
Owner’s Manual - Regal Intensive Care Unit
Gasket, Filter/Fans
Compartment
P/N 754456
There are two sets of gaskets on the filter/fans compartment. One
set is on the rear of the removable panel (front), and the other set is
on the rear of the unit behind the rear utility panel. Each set consists
of four parts, cut to length and bonded to the the panel or unit. If
necessary, you can replace only those gasket segments that are
damaged; it may not be necessary to replace all four segments.
Tool Required
Utility knife
Razor blade
Tape measure
Removal
1. Compartment panel: Open the filter/
fans compartment (refer to Page 58).
Rear of filter fans compartment:
Unscrew the eleven retaining screws and
remove the rear utility panel (Figure 139).
3. With a utility knife, peel the old gasket off
(Figures 151 and 152).
4. With a razor blade, make sure the surface
from which the gasket was removed is
clean and free of old adhesive.
Installation
1. Measure and cut a piece of gasket material
equal in length to the piece being replaced.
2. Peel the protective backing from the new
gasket material.
3. Press the new gasket in place on the door.
4. Compartment panel: Close the filter/
fans compartment.
Rear of filter fans compartment:
Replace the rear utility panel and secure
with the eleven screws.
Figure 151. Filter/Fans Compartment
Panel Gaskets
Horizontal Gasket 2)
Vertical Gasket (2)
Figure 152. Gaskets on Rear of Filter/
Fans Compartment
Horizontal
Gasket (2)
Vertical
Gasket (2)