Filter
Top Products
Form No. 702718 Rev. A March, 2005 111
Owner’s Manual - Regal Intensive Care Unit
14. With a 1/2-in. wrench, remove the nut behind the knob.
15. Remove the nut and internal-star washer from the shaft.
16. Open the electronics compartment door.
17. Pull the complete control assembly out of the door.
Installation
1. From inside the door, place the shaft of the new tempera-
ture control through its opening. Make sure it is oriented
like the other control assembly.
2. Close the electronics compartment door.
3. Place the internal-star washer on the shaft and secure the
assembly in place with the 1/2-in. nut.
4. Turn the shaft fully counter-clockwise.
5. Mount the knob onto the shaft with the indicator line at
about the 9:00 position (pointing left), and secure the knob
with the lock screw.
6. Open the electronics compartment door.
7. Re-connect the ribbon cable to Terminal P1. The wire with
the red stripe should be on top.
8. Re-connect the single wire to Terminal 2.
9. Re-connect the single wire to Terminal 1.
10. Re-connect the two wires to Terminal 7.
11. Re-connect the single wire to Terminal 6.
12. Re-connect the two wires to Terminal 5.
13. Re-connect the two wires to Terminal 4.
14. Close and secure the electronics compartment door.
15. Plug the power cord into its wall outlet.