Filter
Top Products
110 SSCI - Suburban Surgical Company, Inc.
Chapter 5 - Repairs & Replacements
* Wire colors can vary
Table 4. Wire Terminations - Floor Temperature
Controller - Refer to Figure 115 (Same for Left and Right)
4. Using tags, masking tape, or any other convenient means,
tag all of the wires on the temperature controller with their
terminal numbers. Terminal numbers are displayed on the
rear of the control (Figure 122). Failure to mark the wires
will make it difficult to re- connect them correctly.
5. Dis-connect the two wires from Terminal 4.
6. Dis-connect the two wires from Terminal 5.
7. Dis-connect the single wire from Terminal 6.
8. Dis-connect the two wires from Terminal 7.
9. Dis-connect the single wire from Terminal 1.
10. Dis-connect the single wire from Terminal 2.
11. Dis-connect the ribbon cable from Terminal P1.
12. Close the electronics compartment door.
13. Remove the temperature controller knob. Refer to Knob -
Steps 1 through 3, on Page 95.
rebmuNlanimreT *noitacifitnedIeriW :otseoGeriW
3 desuton-tnacaV
4
neerG 6lanimreT
etihW nottuBffO/nO
5
deR
rehtono5lanimreT
lortnoCerutarepmeT
deReldnuBeriW
6 neerG 4lanimreT
7
kcalBegraLretaeHoteldnuBeriW
yarGthgiLmetsyS
1 kcalB rosneSoteldnuBeriW
2 deRrosneSoteldnuBeriW
1P elbaCnobbiReriw-4 yalpsiDlatigiD