Filter
Top Products
Form No. 702718 Rev. A March, 2005 127
Owner’s Manual - Regal Intensive Care Unit
Digital Readout
P/N 854591
Tool Required
Phillips screwdriver
Removal
1. Open the filter/fans compartment (refer to Page 58).
2. With a Phillips screwdriver, un-screw the two screws that
hold the digital readout mounting bracket to the rear of the
panel (Figure 148).
3. With a Phillips screwdriver, remove the two screws that
hold the readout to the bracket.
Installation
1. Mount the bracket to the new readout with the two screws
removed above (Figure 148).
2. Mount the readout/bracket assembly to the panel with the
two screws removed above.
3. Place the F° - C° switch to the desired setting.
4. Make sure there is a battery in the readout. If not, refer to
Page 62.
5. Replace and secure the filter/fans compartment panel.
Figure 148. Digital Readout and Mounting Bracket
Digital
Readout
Mounting
Bracket
Mounting
Bracket-Panel
Screw (2)
Readout -
Mounting
Bracket
Screw (2)
F° - C°
Switch