Filter
Top Products
54
SSCI - Suburban Surgical Company, Inc.
Chapter 4 - Operation and Care
If cooling is required by animals in both half-compartments, use
the wire grill divider so that air can move freely between the
compartments. If only one animal requires coolong, and is small
enough to fit, place it in the right compartment, and install the
acrylic divider (the right compartment contains the air inlet).
To supply cooled air to the animal compartment:
1. Install a divider panel if required, (refer to Page 49).
2. Make sure the main on/off switch is On. The amber light
in the switch must be On (refer to Page 48).
Cooling the
Compartment Air
3. Press the cooling on/off switch to turn
cooling On. The amber light in the switch
comes on (Figure 57).
4. Turn the temperature set dial to the
desired temperature. If the temperature in
the compartment is above the set
temperature, cooling is supplied and the red
system light comes on. The temperature of
the air in the animal compartment can be
read on the digital readout (refer to
Page 24).
When the compartment air reaches the set tempera-
ture, the system light goes out.
Figure 57. Cooling Controls
System
Light
On/Off
Switch
Temperature
Set Dial
To turn cooling Off, press the cooling on/off switch. The light in the
switch goes out. If the cooling system was operating, it stops, and
the system light goes out.