Filter
Top Products
1. LINEAR ENCODER
1 - 16
2) MR-J4-_A_-RJ or MR-J4-_B_-RJ servo amplifier
MR-J4-_A_-RJ
or
MR-J4-_B_-RJ
servo amplifier
Personal
computer
Software for
signal adjustment
Conversion unit
For the signal adjustment and confirmation, connect the following equipments. (Note 2)
2)
Head cable
Linear encoder
ST741A, ST742A, ST743A,
ST744A, or ST748A
3)
1)
Encoder cable 1
Thermistor of linear servo motor
Branch cable
CN2
CN2L
4) SCALE
THM (Note 3)
CN2
3)5)
Thermistor of linear servo motor
Encoder cable 2
Branch cable Encoder cable Head cable
When using an
optional encoder
cable
4) MR-J4THCBL03M
(Refer to section
2.4.)
1) Options manufactured by Mitutoyo (Note 1)
Part No.06ACF117A: 5 m
Part No.06ACF117B: 10 m
Accessories for linear
encoder
Cable length: 1 m
When fabricating
the encoder cable
2) Connector set MR-J3CN2
(Refer to (2) (a) of this
section.)
3) Junction connector (Note 1)
D-SUB15 pin (female)
Shell: HDAB-15S
Plug case: HDA-CTH
(Hirose Electric)
When not using a
branch cable
5) Connector set MR-J3CN2
(Refer to (2) (b) of this
section.)
Note 1. It should be prepared by the customer.
2. When mounting ST741A, ST742A, ST743A, ST744A, or ST748A, a personal computer (with RS-232C port) for the signal
adjustment and confirmation, and a software and conversion unit for signal adjustment are required. For details, contact
Mitutoyo.
3. For connectors for thermistor signals, change how to connect depending on the customer's system.