Mitsubishi Electronics FX3GC Garage Door Opener User Manual


 
38
FX3S/FX3G/FX3GC/FX3U/FX3UC Series
Programming Manual - Basic & Applied Instruction Edition
2 Overview (Sequence Program)
2.6 Program Memory and Devices
c) FX3U/FX3UC PLCs
*1. Device values are not backed up correctly when the battery voltage becomes lower than the holding voltage.
*2. The contents of the program memory and device values are not backed up correctly when the battery voltage
becomes lower than the holding voltage if a memory cassette is not attached.
*3. Some devices are cleared when the PLC status switches from STOP to RUN.
For special data registers, refer to Chapter 37.
*4. An optional memory cassette is required.
Caution
Programs (when a memory cassette is not attached), latched (battery backed) type device values and clock data is not
backed up correctly when the battery voltage becomes low due to expiration of the battery life or another reason.
In such a case, clear latched (battery backed) type devices, transfer programs again (when a memory cassette is not
attached), and then set initial values and clock data if necessary.
For a rough guide to the life and replacement of the battery, refer to the PLC User’s Manual
[Hardware Edition].
For the latched type device initialization method, refer to Subsection 2.6.5.
Item Power OFF
Power
OFFON
STOPRUN RUNSTOP
Data register (D)
General type Cleared.
Does not change. Cleared.
Does not change while M8033 is ON.
Latched (battery
backed) type
Does not change.
*1
File type
Does not change.
*2
Special type Cleared.
Set to initial
values.
*3
Does not change.
*3
Extension register (R)
Latched (battery
backed) type
Does not change.
*1
Extension file register
(ER)
*4
File type Does not change.
Index register (V, Z) V, Z Cleared. Does not change.
Timer present value
register (T)
For 100 ms Cleared.
Does not change. Cleared.
Does not change while M8033 is ON.
For 10 ms Cleared.
Does not change. Cleared.
Does not change while M8033 is ON.
Retentive type for 100 ms
(battery backed)
Does not change.
*1
Retentive type for 1 ms
(battery backed)
Does not change.
*1
Counter present value
register (C)
General type Cleared.
Does not change. Cleared.
Does not change while M8033 is ON.
Latched (battery
backed) type
Does not change.
*1
High-speed type
(battery backed)
Does not change.
*1
Clock data Present value
Does not change.
*1