Filter
Top Products
Setup Menu Teledyne API T801 NDIR CO2 Analyzer Operation Manual
78
5.7.3. COM1[COM2] (MODE, BAUDE RATE AND TEST PORT)
Use the SETUP>COMM>COM1[COM2] menus to:
configure communication modes (Section 6.2.1)
view/set the baud rate (Section 6.2.2)
test the con
nections of the com ports (Section 6.2.3).
Configuring COM1 or COM2 requires setting the DCE DTE switch on the rear
panel. Section 6.1 provides DCE DTE information.
5.8. SETUP VARS: VARIABLES SETUP AND DEFINITION
Through the SETUP>MORE>VARS menu there are several user-adjustable
software variables, which define certain operational parameters. Usually, these
variables are automatically set by the instrument’s firmware, but can be manually
re-defined using the VARS menu.
Table 5-2 lists variables that are available within the 818 password protected
level. See Appendix A2
for a detailed listing of the T801 variables that are
accessible through the remote interface.
07274B DCN6418