Filter
Top Products
Appendix A Models T801, 801E Software Menus (Reference: 06843C DCN6418)
A-14 Error! Unknown document property name.Error! Unknown document property name. Error!
Unknown document property name.Error! Unknown document property name.
Setup Variable Numeric
Units
Default
Value
Value Range Description
TEST_CHAN_ID — NONE
NONE,
SAMPLE
PRESSURE
,
SAMPLE
FLOW,
O2 CELL
TEMP
3
,
CO2 CELL
TEMP
1
,
CHASSIS
TEMP
Diagnostic analog output ID.
Enclose value in double quotes
(“) when setting from the RS-232
interface.
REMOTE_CAL_MODE — O2 RANGE1
5
CO2 RANGE1
4
O2 RANGE1
3
,
O2 RANGE2
5
,
CO2 RANGE1
1
,
CO2 RANGE2
4
Range to calibrate during
contact-closure and Hessen
calibration. Enclose value in
double quotes (“) when setting
from the RS-232 interface.
PASS_ENABLE — OFF OFF, ON
ON enables passwords; OFF
disables them.
STABIL_FREQ Seconds 10 1–300
Stability measurement sampling
frequency.
STABIL_SAMPLES Samples 25 2–40
Number of samples in
concentration stability reading.
SERIAL_NUMBER —
“00000000 ”
Any character
in the allowed
character set.
Up to 100
characters
long.
Unique serial number for
instrument. Enclose value in
double quotes (“) when setting
from the RS-232 interface.
DISP_INTENSITY — HIGH HIGH,
MED,
LOW,
DIM
Front panel display intensity.
Enclose value in double quotes
(“) when setting from the RS-232
interface.
I2C_RESET_ENABLE — ON OFF, ON I
2
C bus automatic reset enable.
07274B DCN6418