Filter
Top Products
Configuration
3-32
9124-A2-LB20-00
March 2000
Assigning Time Slots/Cross Connections
The system allows you to assign data paths between the various interfaces to
share the T1 network. Assuming that the DSX-1 interface is enabled, you can
make the following cross connection assignments:
H Frame relay links to the network interface time slots
H DSX-1 time slots to the network interface time slots
You can also clear cross-connection assignments for the system, or for a
selected slot or interface.
NOTE:
Although it is not required, it is suggested that you progress through each
screen in order, from top to bottom.
Use the following procedures to assign cross connections.
Assigning Frame Relay Time Slots to the Network Interface
Before assigning network time slots for use by frame relay traffic, configure the
Network physical and Frame Relay options (if needed), then allow Time Slot
Discovery to autodetect and assign the appropriate time slots to frame relay.
If there are multiple Frame Relay data links on the network interface, or if
Time Slot Discovery is not currently active, you can manually assign time slots on
the network interface for frame relay traffic using the Frame Relay Network
Assignments screen. This screen is read-only when Time Slot Discovery is set to
Enable for the network interface.