HP (Hewlett-Packard) 3.2.1 Water System User Manual


 
Table 4-23 BIOS Settings for HP ProLiant DL145 G3 Nodes
Set to This ValueOption NameSubmenu NameMenu Name
Off
NumLockBoot OptionsMain
BMC
Serial Port ModeI/O Device ConfigurationAdvanced
Enabled
Serial port A:
3F8
Base I/O address:
IRQ 4
Interrupt:
AUTO
DRAM Bank InterleaveMemory Controller Options
Disabled
Node Interleave
Enabled
32-Bit Memory Hole
Enabled
Embedded SATASerial ATA
SATA
SATA Mode
Enabled
Enabled/Disable Int13
support
Enabled
Option ROM Scan
Enabled
Enable Master
0040h
Latency Timer
On-board COM A
Com Port AddressConsole Redirection
115.2K
Baud Rate
ANSI
Console Type
None
Flow Control
Direct
Console connection
On
Continue C.R. after POST
1
# of video pages to suppor t
DHCP
IP Address AssignmentIPMI/LAN Setting
NIC
LAN Controller:
Disabled
HPET Timer
Disabled
8042 Emulation Support
Disabled
Factory Boot Mode
Set the following boot order on
all nodes except the head node:
1. Removable Devices
2. CD-ROM Drive
3. MBA v9.0.6 Slot 0820
4. Hard Drive
5. MBA v9.0.6 Slot 0821
Set the following boot order on
the head node:
1. Removable Devices
2. CD-ROM Drive
3. Hard Drive
Boot
92 Preparing Individual Nodes