Filter
Top Products
1. Make the RBSU settings accordingly. The settings differ depending on the hardware model
generation:
• Table 4-31 provides the RBSU settings for the HP ProLiant DL385 nodes.
• Table 4-32 provides the RBSU settings for the HP ProLiant DL385 G2 nodes.
Use the navigation aids shown at the bottom of the screen to move through the menus and
make selections.
Table 4-31 RBSU Settings for HP ProLiant DL385 Nodes
Set to This ValueOption NameMenu Name
On all nodes except the head node, set this value
to Enable NIC1 PXE
1
Embedded NIC Port PXE
Support
System Options
On the head node only, set this value to Embedded
NIC PXE Disabled
Disabled
Embedded Serial Port
COM1; IRQ4; IO:3F8h-3FFh
Virtual Serial Port
Enabled (all nodes except the head node)
Embedded NIC Port 1 PXE
Support
Disabled (head node only)
Embedded NIC Port 1 PXE
Support
Disabled
Power Regulator for
ProLiant
Set the following boot order on all nodes except
the head node:
Standard Boot Order (IPL)
1. CD-ROM
2. NIC1
3. Hard Disk
On the head node, set the boot order so that the
CD-ROM is listed before the hard disk.
CD-ROM
IPL1
Floppy Drive (A:)
IPL2
PCI Embedded HP NC7782 Gigabit Server
Adapter Port 1
IPL3
Hard Drive (C:)
IPL4
COM1; IRQ4; IO:3F8h-3FFh
BIOS Serial Console PortBIOS Serial Console and
EMS
115200
BIOS Serial Console Baud
Rate
Disabled
EMS Console
Command Line
BIOS Interface Mode
Disabled
page Directory Cache
(PDC)
Advanced Options
1 A small blue dialog box near the bottom left side of the screen indicates the current setting. You can make only
one setting per node.
Table 4-32 lists the RBSU settings for the HP ProLiant DL385 G2 nodes.
Table 4-32 RBSU Settings for HP ProLiant DL385 G2 Nodes
Set to This ValueOption NameMenu Name
4.7 Preparing the Hardware for CP4000 (AMD Opteron) Systems 103