HP (Hewlett-Packard) 3.2.1 Water System User Manual


 
1. Make the RBSU settings for each node; Table 4-41 lists the RBSU setting for the DL785 G5
nodes.
Table 4-41 RBSU Settings for HP ProLiant DL785 G5 Nodes
Set to This ValueOption NameMenu Name
Disabled
Embedded Serial PortSystem Options
COM1
Virtual Serial Port
On all nodes except the head node, set this value
to PXE boot
Embedded NICs/NIC 1 boot
Options
Disabled (head node only)
Embedded NICs/NIC 2 boot
Options
OS Control Mode
Power Regulator for
ProLiant
Set the following boot order on all nodes except
the head node; the CD-ROM must be listed before
the hard drive:
Standard Boot Order (IPL)
IPL:1 CD-ROM
IPL:2 Floppy Drive (A:)
IPL:3 USB Drive Key (C:)
IPL:4 PCI Embedded HP NC373i
Multifunction Gigabit Adapter
IPL:5 Hard Drive C:
Set the following boot order on the head node:
IPL:1 CD-ROM
IPL:2 Floppy Drive (A:)
IPL:3 USB Drive Key (C:)
IPL:4 Hard Drive C:
COM1
BIOS Serial Console PortBIOS Serial Console and
EMS
115200
BIOS Serial Console Baud
Rate
Disabled
EMS Console
Command Line
BIOS Interface Mode
2. Press the Esc key to exit the RBSU. Press the F10 key to confirm your choice and restart the
boot sequence.
3. Repeat this procedure for each node HP ProLiant DL785 G5 node in the hardware
configuration.
Configuring Smart Arrays
On HP ProLiant DL785 G5 nodes with smart array cards, you must add the disks to the smart
array before attempting to image the node.
To do so, watch the screen carefully during the power-on self-test phase of the node, and press
the F8 key when prompted to configure the disks into the smart array.
Specific instructions are outside the scope of the HP XC documentation. For more information,
see the documentation that came with the HP ProLiant server.
4.7 Preparing the Hardware for CP4000 (AMD Opteron) Systems 115