HP (Hewlett-Packard) 3.2.1 Water System User Manual


 
Figure 4-22 HP ProLiant DL585 G5 Server Rear View
The callouts in the figure enumerate the following:
1. The iLO2 Ethernet port is the connection to the Console Switch.
2. NIC1 is the connection to the Administration Switch (branch or root).
3. If a Gigabit Ethernet (GigE) interconnect is configured, this port (labeled NIC2) is used for
the interconnect connection. Otherwise, it is used for an external connection.
Setup Procedure
Perform the following procedure from the iLO Setup Utility for each HP ProLiant DL585 G5
node in the hardware configuration:
1. Use the instructions in the accompanying HP ProLiant hardware documentation to connect
a monitor, mouse, and keyboard to the node.
2. Turn on power to the node. Watch the screen carefully during the power-on self-test, and
press the F8 key when prompted to access the Integrated Lights Out Setup Utility.
3. Make the following iLO settings for each DL585 G5 node, as shown in Table 4-38:
Table 4-38 iLO Settings for HP ProLiant DL585 G5 Nodes
Set to This ValueOption NameSubmenu NameMenu Name
Create a common iLO user name and password for every
node in the hardware configuration. The password must
have a minimum of 8 characters by default, but this value
is configurable.
The user Administrator is predefined by default, but
you must create your own user name and password. For
security purposes, HP recommends that you delete the
Administrator user.
You must use this user name and password to access the
console port.
AddUser
On
DHCP EnableDNS/DHCPNetwork
115200 (Press the F10 key to save the setting.)Serial CLI
Speed
(bits/seconds)
CLISettings
4. Select FileExit to exit the Integrated Lights Out Setup Utility and resume the power-on
self-test.
5. Watch the screen carefully, and press the F9 key when prompted to access the ROM-Based
Setup Utility (RBSU).
Perform the following procedure for each HP ProLiant DL585 G5 node in the hardware
configuration:
4.7 Preparing the Hardware for CP4000 (AMD Opteron) Systems 111