HP (Hewlett-Packard) 3.2.1 Water System User Manual


 
Table 4-8 iLO Settings for HP ProLiant DL360 G5 Nodes
Set to This ValueOption NameSubmenu NameMenu Name
Create a common iLO user name and password for
every node in the hardware configuration. The
password must have a minimum of 8 characters by
default, but this value is configurable.
The user Administrator is predefined by default,
but you must create your own user name and
password. For security purposes, HP recommends
that you delete the Administrator user.
You must use this user name and password to access
the console port.
AddUser
On
DHCP EnableDNS/DHCPNetwork
115200 (Press the F10 key to save the setting.)Serial CLI Speed
(bits/seconds)
CLISettings
Perform the following procedure from the RBSU for each node in the hardware configuration:
1. Make the following settings from the Main menu. Table 4-9 lists the BIOS settings for HP
ProLiant DL360 G5 Nodes.
Table 4-9 BIOS Settings for HP ProLiant DL360 G5 Nodes
Set to This ValueOption NameMenu Name
COM2; IRQ3; IO: 2F8h - 2FFh
Embedded Serial PortSystem Options
COM1; IRQ4; IO: 3F8h - 3FFh
Virtual Serial Port
Set the following boot order on all nodes
except the head node; CD-ROM does not
have to be first in the list, but it must be
listed before the hard disk:
Standard Boot Order IPL
1. CD-ROM
2. Floppy Drive (A:)
3. USB DriveKey (C:)
4. PCI Embedded HP NC373i
Multifunction Gigabit Adapter
5. Hard Drive C: (see Boot
Controller Order)
On the head node, set the boot order so that
the CD-ROM is listed before the hard disk.
COM1; IRQ4; IO: 3F8h - 3FFh
BIOS Serial Console PortBIOS Serial Console &
EMS
115200
BIOS Serial Console Baud Rate
Disabled
EMS Console
Command-Line
Press the Esc key to return to the main
menu.
BIOS Interface Mode
2. Press the Esc key to exit the RBSU. Press the F10 key to confirm your choice and restart the
boot sequence.
3. Repeat this procedure for each HP ProLiant DL360 G5 node in the HP XC system.
4.5 Preparing the Hardware for CP3000 (Intel Xeon with EM64T) Systems 71