HP (Hewlett-Packard) 3.2.1 Water System User Manual


 
Setup Procedure
Use the Setup Utility to configure the appropriate settings for an HP XC system.
Perform the following procedure for each workstation in the hardware configuration. Change
only the values described in this procedure; do not change any other factory-set values unless
you are instructed to do so:
1. Use the instructions in the accompanying hardware documentation to connect a monitor,
mouse, and keyboard to the node and establish a connection to the console.
2. Turn on power to the workstation.
3. When the node is powering up, press the F10 key to access the Setup Utility.
4. When prompted, press any key to continue.
5. Select English as the language.
6. Make the appropriate settings for the workstation depending on hardware model:
Table 4-42 describes the settings for the xw9300 workstation.
Table 4-43 describes the settings for the xw9400 workstation.
Table 4-42 Setup Utility Settings for xw9300 Workstations
Set to This ValueOption NameSubmenu NameMenu Name
Set the following boot order on all nodes except
the head node; CD-ROM does not have to be first
in the list, but it must be listed before the hard disk:
1. IDE CD-ROM Drive
2. USB device
3. Network Controller
4. Hard Drive (C:)
On the head node, set the boot order so that the
CD-ROM is listed before the hard disk.
Boot OrderStorage
On
After Power LossPo wer/Sleep/W akeAdvanced
Table 4-43 describes the settings for the xw9400 workstation.
Table 4-43 Setup Utility Settings for xw9400 Workstations
Set to This ValueOption NameSubmenu NameMenu Name
Set the following boot order on all nodes except
the head node; CD-ROM does not have to be first
in the list, but it must be listed before the hard disk:
1. Optical Drive
2. USB device
3. nVidia Network Controller 1
4. Hard Drive (C:)
5. nVidia Network Controller 2
Set the boot order on the head node as follows:
1. Optical Drive
2. USB device
3. Hard Drive (C:)
4. nVidia Network Controller 1
5. nVidia Network Controller 2
Boot OrderStorage
On
After Power LossPo wer/Sleep/W akeAdvanced
7. Select FileSave Changes & Exit to exit the Setup Utility.
8. Repeat this procedure for each workstation in the hardware configuration.
9. Turn off power to all nodes except the head node.
4.7 Preparing the Hardware for CP4000 (AMD Opteron) Systems 117