HP (Hewlett-Packard) 3.2.1 Water System User Manual


 
4.7.8 Preparing HP ProLiant DL585 and DL585 G2 Nodes
On HP ProLiant DL585 and DL585 G2 servers, use the following tools to configure the appropriate
settings for an HP XC system:
Integrated Lights Out (iLO) Setup Utility
ROM-Based Setup Utility (RBSU)
HP ProLiant DL585 and DL585 G2 servers use the iLO utility; thus, they need certain settings
that you cannot make until the iLO has an IP address. The HP XC System Software Installation
Guide provides instructions for using a browser to connect to the iLO to enable telnet access.
Figure 4-20 shows a rear view of the HP ProLiant DL585 server and the appropriate port
assignments for an HP XC system.
Figure 4-20 HP ProLiant DL585 Server Rear View
!
1
2
133MHz
12345678
PCI-X
64-
Bit
100M
Hz
12
iLO
2
1
UID
The callouts in the figure enumerate the following:
1. The iLO Ethernet port is the connection to the Console Switch.
2. If a Gigabit Ethernet (GigE) interconnect is configured, this port is used for the interconnect
connection. Otherwise, it is used for an external connection.
3. NIC1 is the connection to the Administration Switch (branch or root).
Figure 4-21 shows a rear view of the HP ProLiant DL585 G2 server and the appropriate port
assignments for an HP XC system.
Figure 4-21 HP ProLiant DL585 G2 Server Rear View
UID
23 1
The callouts in the figure enumerate the following:
106 Preparing Individual Nodes