Filter
Top Products
217
Introduction to the Quaternary Pump
Optional Interface Boards
LAN Board
The HP LAN board is actually an HP JetDirect card, which is a network
interface card used in HP printers.
NOTE One board is required per Agilent 1100 stack. If the Agilent 1100 stack
has a DAD, then the DAD MUST be the module used for LAN board
installation. If no DAD is present a pump should be used for the LAN
board installation.
NOTE The LAN board can only be used together with:
A DAD/MWD/VWD/Pump/ALS with main board version G13XX-66520 and
greater. An FLD/RID with main board version G13XX-66500 and greater.
a DOS-ChemStation software revision A.06.01 or above.
The following boards can be used with the Agilent 1100 modules.
NOTE Minimum firmware of the LAN boards is A.05.05.
Recommended Cables
For point to point connection (not using a network hub) use a twisted pair
cross over LAN cable (P/N 5183-4649, 10 feet long).
For standard network connections using a hub use category 5 UTP cables,
(P/N G1530-61480, 8 m long).
Table 30 LAN Boards
Agilent Order Number Supported networks
J4106A Ethernet/802.3, RJ-45 (10Base-T)
J4105A Token Ring/802.5, DB9, RJ-45 (10Base-T)
J4100A Fast Ethernet, Ethernet/802.3, RJ-45 (10/100Base-TX) + BNC
(10Base2)