Filter
Top Products
21
Installing the Pump
Optimizing the Stack Configuration
Figure 2 Recommended Stack Configuration (Rear View)
NOTE If a single stack configuration becomes too high, e.g. if an additional module
like a G1327A ALS Thermostat is added or if your bench is to high, a two stack
configuration may be a better setup. Separate the stack between pump and
autosampler and place the stack containing the pump on the right side of the
stack containing the autosampler.
Analog signal to
recorder,for
PN see page 181
Pressure output to
recorder, for
PN see page 181
AC power
Remote cable
5061-3378
CAN Bus cable to
handheld controller
G1323-81600
CAN Bus cable for inter
module communication
5181-1516 (0.5m)
5161-1519 (1.0m)
GPIB or
LAN to ChemStation
for PN see page 181