Filter
Top Products
42
Home Automation, Inc.
into the alarm state. So we program
button 21 to turn unit 5 on for 5
minutes.
Press PROG, *(button), 2, 1, ENTER,
UNIT-NUMBER, 5, TIME, 5, ON.
The display should show “WHEN Z6
ALM: - STAIRWELL ON FOR 5”.
Press ENTER to commit the program to
memory.
SECURITY ARMING ACTIVATED
BUTTONS
Certain buttons are automati-
cally activated upon security arm-
ing status changes. These buttons
are activated when the system is
put in the OFF, HOME, ASLEEP, or
AWAY modes. When arming the system
into the HOME, ASLEEP or AWAY
modes, the button is activated
after the EXIT DELAY. Programs that
change the security arming mode
activate these buttons. Quick arm-
ing also activates these buttons.
Table 1 in the Appendix shows
which buttons are activated by
which zones.
EXAMPLE 3: Program the AWAY mode
to turn off all lights and turn on
the energy saver (unit 17). From
Table 1, we determine that button
178 is activated when the security
system is armed in the away mode.
Press PROG, *(button), 1, 7, 8, ENTER,
ALL, OFF.
The display should read “WHEN
AWAY: - ALL OFF”.
Press ENTER to commit the program to
memory. Continue programming:
Press *(button), 1, 7, 8, ENTER, UNIT-
NUMBER, 1, 7, ON.
The display should read “WHEN
AWAY: - ENERGY SAVER ON”.
Press ENTER to commit the program to
memory.
CONDITIONALIZED PROGRAMS
NOTE: In UL Listed Installa-
tions, conditionalized programs
shall not be used to control the
security mode.
Timed programs and event buttons
may be conditionalized such that
the programmed command is only
executed if the specified condition
is true. Programs may be
conditionalized by:
- Darkness (using the sunrise/
sunset calculation)
- Time Clock 1 - 3 on or off
- Zones closed/secure or open/in
alarm
- Security mode (OFF, HOME,
ASLEEP, or AWAY).
A program conditional may be
specified by selecting the *IF
option from the programming menu by
pressing the * key. If no condi-
tional is specified, the programmed
command will always be executed
when activated.
To allow a program to only be executed
if it is light outside, i.e. after
sunrise but before sunset, press *, AM.
To allow a program to only be executed
if it is dark outside, i.e. after
sunset but before sunrise, press *, PM.