Filter
Top Products
19
Model 1503 Owner's Manual
When the last call is made in the
MEDICAL DIAL ORDER, the house
phones are reconnected and the
system stops dialing.
- The console beeper continues to
sound and the lights continue to
flash until the alarm is turned
off.
At any time, the alarm system
can be turned off by the console.
Medical alarms can also be turned
off by pressing the CANCEL key.
DURESS CODE ENTERED or DURESS
ALARM ACTIVATED
(See DURESS CODE for a descrip-
tion of when to use the DURESS
CODE.)
In the event that you enter your
duress code, or a zone configured
as a duress zone is tripped, the
system performs a silent dial out
as follows:
- No alarms, lights or console
beepers are activated. The sys-
tem does not display the duress
alarm.
- The system waits the dial out
delay, then begins to dial out.
If you are having your system
monitored by a central station, the
central station will be sent a code
representing the type of alarm
(duress.)
If you are not using central
station monitoring but are using
the voice dial out capability, the
system looks at the BURGLAR DIAL
ORDER to determine which number to
call first, and calls that number.
If you are using both central
station monitoring and voice dial
out, then the voice dial out is
delayed by five minutes to give the
central station time to call you
back.
For the voice dialer, the system
dials the first number in the BUR-
GLAR DIAL ORDER and delivers the
message: “EMERGENCY... EMERGENCY...
THE BURGLAR ALARM HAS BEEN ACTI-
VATED AT THE FOLLOWING ADDRESS:
(Your address is spoken here*)
PHONE NUMBER (your phone number
that is stored in SET-UP location
MY PHONE NUMBER is spoken here)
THIS IS A SILENT ALARM. PLEASE
RESPOND IMMEDIATELY.”
*NOTE: Model 1503-LC systems do not
speak the address, only the phone
number.
ALARM RESET
The alarm system will reset it-
self after the outside siren has
been on for 4 minutes. When the
alarm system resets, any zone that
is not in alarm is reactivated, so
the alarm system will be activated
again if the zone is tripped. If a
zone has been left in alarm, i.e. a
door has been left open, it will be
automatically bypassed when the
alarm resets.
The console display will indi-
cate “(FIRE, BURGLAR or EMERGENCY)
ALARM RESET” when this happens. The
FLASH FOR ALARM lights will con-