Filter
Top Products
31
Model 1503 Owner's
Manual
these outputs, such as a sprinkler
system, your dealer will explain
its operation.
Auxiliary outputs cannot be
brightened or dimmed.
Auxiliary outputs are NOT af-
fected by ALL ON or ALL OFF com-
mands.
The current status (on or off) of the
auxiliary outputs can be seen on the
console by pressing SHOW, 1
(AUXiliaries)
MODEL 1102 EXPANSION ENCLOSURE
(Model 1503 Version 2 only)
A Model 1503 Version 2 system
can be expanded to control more
points using one to four Model 1102
Expansion Enclosures.
NOTE: When one or more Model
1102s are used, zones and units 17,
18 and 19 (auxiliary inputs and
outputs 1, 2 and 3) are moved from
the Model 1503 to the first three
zones and relays of the 1102.
The Model 1102 has 16 inputs or
zones. These zones can be config-
ured as burglary zones, fire zones,
temperature inputs or as auxiliary
inputs for home control purposes.
It also has 16 low voltage relays
that can be controlled as unit
numbers.
Zones and unit numbers on Model
1102 Expansion Enclosures are:
- 1st Model 1102: Zones 17 -
32
Unit numbers 17 -
32
- 2nd Model 1102: Zones 33 -
48
Unit numbers 33 -
48
- 3rd Model 1102: Zones 49 - 64
Unit numbers 49 -
64
- 4th Model 1102: Zones 65 - 80
Unit numbers 65 -
80
The Model 1102 relays can switch
low voltage loads to control sprin-
klers, operate lighting, motor and
water heater controls, etc.
SCROLLING THROUGH NAMES
The Model 1503 stores names for
zones, units and buttons, so that
you don't have to remember that
“unit 5” is the “den light” and
“zone 1” is the “FRONT DOOR”. In
general, any time you need to enter
a zone, unit or button number, you
can press the SHOW key to display
the first name, then use the SHOW
and SET-UP keys (up and down ar-
rows) to scroll through the list.
This is true when entering commands
and programming on the console.
In a system with lots of units,
you can also “guess” where a name
is by entering a number that you
think is close, then using SHOW and
SET-UP to zero in on the right one.
For example, pressing UNIT-NUMBER,
4, SHOW, SHOW, 12, SET-UP, SET-UP
will display the name for unit 4,
5, 12, and 11. Then you can press
ON, OFF, TIME, etc. to operate unit
11.
On Model 1503 Version 2 systems,
the display will skip over unit
numbers that are unused. The system