Filter
Top Products
9
OUTDOOR
COIL
C09219
Fig. 11 -- Cleaning Condenser Coil (S ize 04--07 shown)
C08206
Fig. 12 -- Propping Up Top Panel
4. For Size s 04--07: Remove screws securing coil to
compressor plate and compressor access panel.
5. For Sizes 08--09: Remove fastener holding coil sec-
tions together at return end of condenser coil. Care-
fully separate the outdoor coil secti on 3 to 4 in. from
the inner coil section. See Fig. 13.
OUTDOOR
COIL
C09220
Fig. 13 -- Separating Coil Sections
6. Use a water hose or other suitable equipment to flush
down between the 2 coil sections to remove dirt and
debris. Clean the outer surfaces with a stiff brush in
the norm al manner.
7. Secure inner and oute r coil rows toget her with a
field--supplied fastener.
8. Reposition the outer coil section and remove the coil
corner post from between the top panel and center
post. Reinstall the coil corner post and replace all
screws.
Totaline Environmentally Sound Coil Cleaner
Application Equipment
S 2
1
/
2
gallon garden sprayer
S Water rinse with low velocity spray nozzle
UNIT DAMAGE HAZARD
Failure to follow this caution may result in corrosion
and damage to the unit.
Harsh chemicals, household bleach or acid or basic
cle aners should not be used to c lean outdoor or indoor
coils of any kind. These cleaners can be very difficult
to rinse out of the coil and can accelerate corrosion at
the fin/tube interface where dissimilar materials are in
contact. If there is dirt below the surface of the coil,
use the Total ine environmentall y sound coil cleaner as
described above.
CAUTION
!
UNIT DAMAGE HAZARD
Failure to follow this caution may result in reduced
unit performance.
High velocity water from a pressure washer, garden
hose, or compressed air should never be used to clean
a coil. The force of the water or a ir jet will bend the
fin edges and increase airside pressure drop.
CAUTION
!
Totaline Environmentally Sound Coil Cleaner
Application Instructions
1. Prope r eye protection such as sa fety glasses is recom-
mended during mixing and application.
2. Remove all surface loaded fibers and dirt with a vacu-
um cl eaner a s describe d above.
3. Thoroughly wet finned surfaces with clean water and
a low velocity garden hose, being carefull not to bend
fins.
4. Mix Totaline environmentally sound coil cleaner in a
2
1
/
2
gallon garden spryer according to the instruc-
tions included with the cleaner. The optimum solution
temperature is 100°F(38°C).
NOTE: Do NOT USE water in excess of 130°F(54°C), as
the enzymatic activity will be destroyed.
5. Thoroughly apply Totaline environmentally sound
coil cleaner solution to all coil surfaces including
finned area, tube sheets and coil headers.
6. Hold garden s pr ayer nozzle close to finned areas and
apply cleaner with a ver tical , up--and--dow n motion.
548J