Filter
Top Products
Instruction 24-94484-22
Operation
4.14.2 Computer to PCA 2 Connection &
USB Device Driver Installation
Connect the USB cable (P/N 104-4032) that was supplied with the PCA 2,
and, if necessary, install the analyzer’s USB device driver as follows:
1. With both the PCA 2 and computer turned ON, insert the appropri-
ate ends of the USB cable into the USB connectors on the PCA 2 and
computer as shown in Figure 4-2.
2. If this is the first time the PCA 2 is being connected to the computer,
then the “Found New Hardware Wizard” should shortly appear. Select
“No, not this time” and click Next>.
Figure 4-2. Computer to PCA 2 Connection
Do not search for
software.
NOTE: The USB
device driver
only needs to be
installed once. It
does not require
to be re-installed
each time the
PCA 2 is con-
nected to the
computer.