Bacharach 24-9448 Carbon Monoxide Alarm User Manual


 
Instruction 24-9448 3-9
Initial Setup
3.10 Time Setup
The time is stored in the format: hh:mm:ss
AM/PM. Its value is part of the date and time
stamp that is saved along with each combustion
test record.
Set the analyzer’s internal clock to the current
time as follows:
1. Display the MAIN MENU by pressing the
MENU (F2) button. If necessary, press ESC
until MENU appears above F2.
2. Use the buttons to highlight SETUP,
and then press ENT to display the SETUP
MENU.
3. Use the buttons to highlight TIME, and
then press ENT to display the TIME MENU.
4. First use the buttons to move the cursor
across the screen until it is over the digit to
be changed, and then press the buttons
until the desired value is displayed.
5. Repeat Step 4 until the values for hour, min-
ute, and meridiem have been set.
NOTE: The value for seconds cannot be en-
tered, but are displayed and stored as part of
the combustion test record.
6. Press ENT to save the displayed time values
and re-display the SETUP MENU, or press
ESC to abort this procedure and retain the old time values.
MAIN MENU
FUEL
PRESSURE
MEMORY
SETUP
CALIBRATION
DIAGNOSTICS
STATUS
F1 F2 F3
MENU
SETUP MENU
TEMP UNITS
PRESSURE UNITS
POLLUTION UNITS
DATE
TIME
O2 REF
PRINT PRESSURE
(more)
MENU
F1 F2 F3
TIME MENU
TIME 09:25 AM
05/26/06 09:25:30 AM
MENU
F1 F2 F3