Filter
Top Products
From the back, insert a pop rivet into a nail slot above one of
the locking tabs. Then place a cam clip and a washer over the
pop rivet. Squeeze the pop rivet gun to set the clip. Repeat
over each locking tab area. Now you are ready to install the
new panel.
Install 4 cam clips in nail slot locations from left to right 3, 13,
18, 28.
Installing the new panel
Slide the left side of the new panel into the side locking tabs.
As you raise the new panel into position, make sure the
bottom lip of the panel engages the locking tabs on the panel
below. Also, be sure all the cam cords hang down and are
visible.
Lift up the panel above the new panel far enough to place the
nails into the old nail holes.
97
Wolverine Fit and Finish Installation Guide