Filter
Top Products
For nailing instructions, see page 24.
Tools Required
Hammer Tin snips Tape measure
Square Chalk line Level
Utility knife Hacksaw Shears
Power circular saw with sharp, fine-tooth plywood blade
mounted in reverse direction.
Ladders and scaffolds
NOTE: If you will be using an extension ladder during
installation, be sure to cushion the upper side rails to
help prevent damage to installed siding.
Cutting table
Portable brake
Essential for bending aluminum trim coil to fit around fascia
boards, window sills, window and door casings, etc. Please
refer to the brake manufacturer’s instructions for metal
bending techniques.
Transporting and Storing Vinyl Siding
If you are transporting vinyl siding to a job site, make certain
to keep cartons flat and supported along their entire length.
At the job site, take the following precautions when storing
panels:
• Store on a flat surface and support the entire
length of the carton.
• Keep cartons dry.
• Store away from areas where falling objects or other
construction activity may cause damage.
• Do not store in any location where temperatures may
exceed 130° F (e.g., on black top pavement during
unusually hot weather or under dark tarps or plastic
wraps without air circulation).
15
Wolverine Fit and Finish Installation Guide