Filter
Top Products
Replacing a Damaged Siding Panel
To remove a damaged panel, insert the hook end of a zip tool
into the lock between the damaged panel and the panel
above. Pull downward. This will allow access to the damaged
panel’s nail flange. Remove the nails securing the panel.
NOTE: The nails may be allowed to stay in the wall if they
are driven flush with the substrate after the damaged
panel is removed. Remove damaged panel and install a
new panel, then use the zip tool to lock the new panel into
the panel above.
Replacing a Damaged
Outside Corner Post
Remove face portion of damaged post by scoring along
outside corner of receiving channel with a utility knife.
Remove the nailing flanges from the new cornerpost by
scoring and bending until the flanges snap off. Be sure to
score along inner corner of receiving channel.
Lap partial receiving channel of new post over partial channel
on remaining nail flange. Pop rivet the two receiving channel
legs together as needed.
112
SECTION 10 – Repair
Wolverine Fit and Finish Installation Guide