Filter
Top Products
Corner Blocks
Corner Block
Install starter as previously described. Measure and cut the
side lineals to the exact size of the window or door opening.
Cut the top and bottom lineals 1/4" longer than the window.
Using vinyl snips, make two 1" long cuts in the pocket areas
on both sides of each lineal. These cuts allow the lineals to
connect with the corner block and help provide proper
drainage.
NOTE: It may be helpful to hold off securing the lineals
until the corner block is in place.
Position the corner block by inserting the top lineal into the
corner block’s receiving area – making sure the lineal’s pocket
is inside that of the corner block.
Position the vertical (side) lineal into the corner block by
inserting the pocket of the corner cover into the pocket of the
lineal. This will ensure proper drainage.
Corner Block with Rosette
Locate the small dimple on the back side of the block’s face
or measure 2-5/16" as shown and mark.
Drill or punch a 3/32" - 1/8" diameter hole through the face of
the block – the hole must not be larger than 1/8".
NOTE: Check the back side of the block for this location –
marked by “+”.
Apply the rosette clip from the backside. If desired, a small
amount of caulk can be applied over the hole prior to applying
the rosette.
46
Wolverine Fit and Finish Installation Guide
rosette clip
rosette center
(back side)
2-5/16"
2-5/16"
1/8" per side
make 1" cuts