Filter
Top Products
5" Angled Header with End Caps over
3-1/2" Lineals Sides and Bottoms
Assemble the 5" header and cap. The side 3-1/2" lineals
should extend approximately 1" inside the header assembly.
Finish the corner by sliding the 3-1/2" side lineals behind the
header, making sure the 2" rain tab on the end cap extends
into the receiving area of the side lineals.
49
Wolverine Fit and Finish Installation Guide
1-1/2" - 1-3/4"
slit in pocket
area of the 3-1/2"
side lineals
3-1/2"
1-1/8"
removing this
section allows
side 3-1/2" lineal
to slide behind
the 5"
5"
lineal
header
2" rain tab
3/4" end cap
(from 5" lineal)
3/4"
3/4" rain tab