Filter
Top Products
Installing Restoration Shapes
Half-Rounds on Non-vertical Walls
Half-Rounds must never be used as a roofing material.
However, they can be used on non-vertical walls that meet the
following conditions:
The non-vertical wall must not be greater than 10° off the
vertical (no less than an 80° angle).
The top of the wall cannot be higher than 33' above ground
level.
The non-vertical wall must not be a functional roof above
occupied space. It must be decorative.
Before you install Half-Rounds panels on a non-vertical wall,
install an underlayment of 15 lb. (minimum) felt or
waterproofing shingle.
Cap the uppermost edge of the top siding course to prevent
the water from getting behind the siding. Flash all accessories
to shed water away from the substrate, just in case water gets
behind the siding in these areas.
no more than 33'
no less
than 80°
91
Wolverine Fit and Finish Installation Guide